Size:
4
Pay in installments of $5.79 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 1 - Jul 6
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
waterproof dressing for tattoos Tattoo Aftercare Clear Adhesive Bandange Waterproof Dressing Roll – Tattoo GizmoThis After Inked Tattoo Dressing is a transparent waterproof bacterial barrier that covers and protects new fresh tattoos from exposure to dirt and abrasion. It consists of a thin film with a medical grade adhesive backing that gently, yet securely, adheres to the skin. Micropores make the dressing breathable, allowing moisture vapor to escape while containing the normal exudate from the new tattoo. After Inked is Formulated for Perfection and the
This After Inked Tattoo Dressing is a transparent waterproof bacterial barrier that covers and protects new fresh tattoos from exposure to dirt and abrasion. It consists of a thin film with a medical-grade adhesive backing that gently, yet securely, adheres to the skin. Micropores make the dressing breathable, allowing moisture vapor to escape while containing the normal exudate from the new tattoo. After Inked is Formulated for Perfection and the Premium brand used and recommended by World-Renowned Tattoo Artists. Made in USA.
Directions of use:
- Wash your hands thoroughly prior to application. Always wear gloves when applying the tattoo dressing to someone else.
- Gently cleanse the tattoo and surrounding shaved skin with warm water Rinse well with clean water. Lightly pat dry with clean wipe or air dry thoroughly.
- Remove the sheet from the pouch. Peel the liner from the dressing to expose the adhesive surface. Place the dressing on the tattoo and apply firm pressure so it sticks to the skin. with clean water.
- LightRemove the paper backing starting from the center cut, applying pressure on the film while removing the paper. Do not stretch the dressing during application.ly pat or air dry.
- Cover tattoo completely plus 1” all around for good adhesion. It is OK to overlap more than one piece. Make sure all edges are sealed. often as needed to remove dirt and debris.
- Do not leave the dressing on for more than 24 hours. If the dressing leaks or becomes loose, remove it.
Directions for Removal:
- Wash your hands thoroughly. Find an edge of the dressing, lift it and slowly peel it back over itself until the entire dressing lifts. Avoid stretching the skin.
- Gently cleanse the tattoo and surrounding skin with warm water
- Lightly pat dry with clean wipe or air dry thoroughly.
- Apply After Inked Tattoo Moisturizer and continue to moisturize daily.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.5 ★★★★★
Based on 1700 reviews
Sort
Product Reviews
★★★★★ 5
It works as expected
Size: 8.3" x 9.3" x 1.3"
Great. It does block air flow by a bit, but it is ok, if you don't need strong air blowing your face at maximum setting all the time.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 14, 2025
★★★★★ 5
Great cabin filter for 2019 Acura RDX
Size: 8.3" x 9.3" x 1.3"
When I have my car serviced at the Acura dealership, they routinely recommend that the cabin filter be replaced. As we all know, a dealership is going to charge an arm and a leg for a basic service. Therefore, I have been replacing the cabin air filter myself for the past few years. I like BOSCH products and when I found this filter on Amazon, I knew that was the one to purchase for my 2019 Acura RDX. The filter fits perfectly in its location in the glove box. It literally takes less than five minutes to swap out the old filter for the new. I will continue to use this product while I have the RDX.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 30, 2025
★★★★★ 5
Perfect fit, easy installation.
Size: 8.3" x 9.3" x 1.3"
This part fits perfectly. Directional flow is printed on the part however you need to confirm which way air flows in the actual air box. The easiest test is to run the a/c with the filter out, wet a finger, and stick in in the air box to see which side the air blows cold. Then just install this part in the air flow direction as printed on the part. I have not noticed a difference in air quality yet, however I imagine being a HEPA filter, this will do wonders keeping pollen out of the car. Installed this in a 2011 Honda CR-Z. Easy installation. Part looks high quality which is fitting for Bosch.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 26, 2026
★★★★★ 4
Great filter, but doesn't fit 2013 Honda Fit without modification
Size: 8.3" x 9.3" x 1.3"
Right off the bat: I don't have any airflow problems with this filter. It works great, the air is noticeably cleaner, and airflow has not been meaningfully reduced. However, it doesn't fit my air filter holder very well.
The ' air filter holder' (a plastic tray that slides horizontally into the air flow system) has two plastic fringes on either side of the tray, which each have two small notches in them, a few inches apart from one another. This appears to act as a sort of 'key' by which you can gauge you are putting the filter in with the correct alignment. On an OEM filter, the slots line up with two strips of material that stretch across the length of the filter, which themselves rest within the slots. However, the slots don't line up with the strips on this filter. I had to cut the fringes so that the slots in them are wider, so the strips would fit in them. Without doing this, the filter wouldn't press down into the tray.
Having done that, and the filter now rests flush in the tray, there are still marginal gaps around the perimeter of the filter. It's a millimeter or two too small for the tray, so there is some airflow around the filter. This could be rectified by wrapping insulation tape or something around the edge of the filter, or could be ignored if you're not super picky. I haven't added any wrapping to get an airtight seal, and even with that gap I still noticed that the air is way better.
So ultimately, it didn't fit exactly, but it fits 90% of the way and, with some finagling, is a superior filter by any other measure.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 3, 2018
★★★★★ 5
Don't overlook this important bit of maintenance
Size: 8.3" x 9.3" x 1.3"
Cabin air filters get dirty and gross quicker than you realize. I recommend changing them twice a year. Bosch is a quality brand, very happy with it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 8, 2026
recommand products
Vina Lace Slip Dress
28.51
Simone Rocha Black Lace Trim Midi Dress
21.91
party black short dresses Black Mini Dress Birthday Party Gown Short Prom Dresses – jkprom
26.16
Dolce & Gabbana Lace Trim Satin Slip Dress Black with DG Logo Plaque
23.44
Dior // Vintage Satin & Lace Slip Dress – VSP Consignment
26.45